1 2 4 8 Channel 5V 12V 10A Relay Module with Optocoupler

NOTE: Please Select only 5V for Arduino, Orange Pi, and Raspberry Pi

NOTE: Please Select only 5V for Arduino, Orange Pi, and Raspberry Pi

NOTE: Please Select only 5V for Arduino, Orange Pi, and Raspberry Pi

Relays are used to control or switch devices which uses a higher power than what most micro-controllers such as an Arduino or Raspberry Pi can handle. This particular relay module can control typical household appliance up to 10A.

*1 Channel 5V 10A Relay Module with Optocoupler

Features:

•One normally closed contact and one normally open contact

•Triode drive, increasing relay coil

•High impedance controller pin

•Pull-down circuit for avoidance of malfunction

•Power supply indicator lamp

•Control indicator lamp

Specification:

•Channel: 1 Channel

•Relay Voltage: 5V

•Dimensions: 56.5mm x 17mm x 20mm

•Weight: 16.5g

*2 Channel 5V 10A Relay Module with Optocoupler

Specs:

- 250VAC 10A, 28VDC 10A

- Indicator LEDs

- 5V control voltage

*4 Channel 5V 10A Relay Module with Optocoupler

The 4 channel Relay Module SPDT (Single Pole Double Throw) can control up to 4 separate devices individually. Relays are typically used to switch devices which uses a higher voltage than what most micro-controllers such as an Arduino or Raspberry Pi can handle. This particular relay module can control typical household appliance up to 10A.

Specs:

- 250VAC 10A, 28VDC 10A

- Indicator LEDs

- 5V control voltage

*8 Channel 5V 10A Relay Module with Optocoupler

Features:

- This 8 channel 5V relay has both optical and magnetic isolation, providing a lot of protection to the inputs from electrical faults on the outputs.

- Works well with both 3.3V and 5V logic (Raspberry Pi, Arduino, Teensy..), requiring little current drive.

- Breadboard friendly, using Female/male dupont makes it extremely convenient for prototyping.

- LED indicates its working status. Red refers to errors.

- 3 terminals per SPDT relay.

*1 Channel 12V 10A Relay Module with Optocoupler

Specifications:

- 250VAC 10A, 28VDC 10A

- Indicator LEDs

- 12V control voltage

- Module size: 55mm x 16mm

Note: PCB color, or layout may vary slightly.